Buffalo TeraStation 1000 User Manual page 41

7
Close the front panel.
TS1200D
8
When the replacement hard drive is recognized, an I31 message will be displayed in NAS Navigator2.
9
Hold down the function button on the front of the TeraStation for 3 seconds.
For JBOD:
The drive will be formatted as an individual drive. Create a shared folder on the drive before use.
For RAID 1, 10, 5, or 6:
The TeraStation will start rebuilding the RAID array automatically. After a few minutes, the I18 message will be
displayed until the drive finishes rebuilding.
Note: If the TeraStation shuts down while rebuilding the RAID array, the RAID rebuild will cancel and will not
start again after the TeraStation boots. To restart the RAID rebuild, log in to Settings and go to Drives - RAID, then
click Rebuild RAID Array.
Drive Replacement (using a redundant RAID mode such as RAID 1 with auto-
shutdown enabled)
This section describes the process of replacing a drive while
1
Turn the TeraStation off and remove all cables.
2
Squeeze the left side of the front panel and pull the panel off.
3
Pull the failed drive's cartridge out from the TeraStation.
Notes:
• Do not press hard on the top of the TeraStation.
• Pull the drive straight out the front of the chassis.
4
Remove the drive from the cartridge.
5
Install a new drive (sold separately) in the cartridge.
6
Replace the four screws.
7
Insert the new drive in the empty slot.
2
D IS K
1
D IS K
TS1400D
2
the TeraStation is off.
40
1