Buffalo TeraStation 1000 User Manual page 7

2
Function LED
This LED glows while the TeraStation is being initialized and while dismounting USB devices.
3
Function Button
Use this button for Direct Copy, dismounting USB devices, rebuilding RAID arrays, and initializing settings.
4
Drive Status LED
If an error occurs on a drive, its corresponding LED will light or blink. For TS1400D models, this LED will blink
green to indicate that drive status is normal.
5
Power Switch/Power Button
For TS1200D models, move the switch up and down to power on and off. For TS1400D models, press the
button to power on and hold it down until the TeraStation beeps to power off.
6
Init Button
Use this button when applying saved settings from a USB drive.
7
USB 3.0 Port
Compatible Buffalo USB 3.0 hard drives, USB flash drives, digital cameras, and USB printers can be connected.
USB hubs are not supported.
8
USB 2.0 Port
Compatible Buffalo USB hard drives, USB flash drives, digital cameras, USB UPS connection, and USB printers
can be connected. USB hubs are not supported.
9
LAN Port
Connect to a router, hub, or switch on your Ethernet network with the included Ethernet cable.
10
Link and Activity LED
This LED shows network activity. It blinks green when the TeraStation is accessed over the network.
11
Power Connector
Use the included power cable to connect to a surge protector or outlet.
Note: Disconnecting the AC cable from the TeraStation, even if it is not powered on, may cause the TeraStation's
time to become incorrect.
12
Power Status LED
The LED glows green when the power cable is connected.
13
Fan
Do not block the fan.
14
Anti-Theft Security Slot
Use this slot to secure your TeraStation with a cable lock (not included).
15
Not in use.
6