Wireless Cylinder Thermostat (Cs92) - Honeywell evohome Installation Manual

P16

Wireless Cylinder Thermostat (CS92)

Central
Controller
If you are NOT following
GUIDED CONFIGURATION
follow these steps on your
Central Controller display
first:
1. Press and hold
"Settings" for 3
seconds
2. Press the green tick
3. Select GUIDED
CONFIGURATION
4. Press STORED
HOT WATER
CONFIGURATION
5. Press the green tick
Step 3: Power up and bind devices
Power up and bind a Wireless Cylinder
Thermostat Transceiver (CS92)
On the CS92 Transceiver
Remove the CS92 Transceiver cover
1
Remove the battery tab and replace the cover
2
On the CS92 Transceiver press and hold the
3
button for 5 seconds. The green light should
come on and the red light should flash
Press the button again
4
You should receive a SUCCESS message on the
5
Central Controller (if not go back and re-bind)
Choose the correct hot water valve type for the system
6
you're installing and follow the on screen instructions
1
3
1 2
PUll TAB
HOlD
5 SEC
PRESS
ONCE