Radiator Controllers (Hr92) - Honeywell evohome Installation Manual

P14

Radiator Controllers (HR92)

Central
Controller
If you are NOT following
GUIDED CONFIGURATION
follow these steps on your
Central Controller display
first:
1. Press and hold 'Settings'
for 3 seconds
2. Press the green tick
3. Press ADD ZONE
4. Press the zone you want
to add the Radiator
Controller to
5. Rename the zone if
required and/or press the
green tick
6. Press RADIATOR VALVE
7. If you want to control the
zone temperature with
the Central Controller
(which needs to be
located in that zone)
press YES, otherwise
press NO.
You must repeat these steps
for each radiator controller.
1 2
Step 3: Power up and bind devices
Power up and bind Radiator Controllers
(HR92) – Your evo Zone Kit
Bind the Radiator Controllers (HR92)
Remove the circular top cover
1
Open the battery clip and insert the AA batteries supplied
2
Close the clip and replace the cover
3
Press the button once − it should say UNBOUND
4
Press and hold the
5
5 seconds until it says BIND
Press the button once – it should say BINDING
6
You should receive a SUCCESS message on the
7
Central Controller (if not go back and re-bind)
The name of the allocated zone should appear on
8
the HR92 display when you press the
Either press the green tick
9
radiator to the zone. Or press the red cross
you don't need to add another radiator to the zone
4 5
PRESS
ONCE
button for a further
to add another
6
PRESS PRESS
5 SEC ONCE
button
if