Honeywell evohome Installation Manual page 35

P33
evohome Installation Guide
Digital Room Thermostat (DTS92)
Put Room Thermostat into standby mode (show icon)
1
Press up and down together for 3 seconds
2
Press down once, the display should say CONT
3
Press down for 3 seconds, the display should say TEST
4
The Central Controller will display the signal strength
(poor to excellent) and the Room Thermostat will
display a signal strength rating from 1 (poor) to 5
(excellent) – 0 means the Room Thermostat has not
received a test signal from the Central Controller.
To exit test mode, press off on Room Thermostat for 5
5
seconds. It will exit automatically after 10 minutes.
2
PRESS FOR
3 SECONDS