Honeywell evohome Installation Manual page 23

P21
evohome Installation Guide
To bind a Room Temperature
Sensor (HCW82 or HCF82)
Press the bind button on the bottom right hand
1
corner of the unit once. The red LED light will flash
You should receive a SUCCESS message on the
2
Central Controller (if not go back and re-bind)
1
Then, on the Wireless Relay Box (BDR91)
Press and hold the button for 15 seconds (until the red
1
LED blinks rapidly) to clear any previous binding data
Press and hold the button again for 5 seconds
2
(until the red LED blinks slowly)
On the Central Controller press the green bind button
3
You should receive a SUCCESS message on the
4
Central Controller (if not go back and re-bind)
1 2
HOlD
15 SEC
HOlD
5 SEC