Wireless Relay Box (Bdr91) - Honeywell evohome Installation Manual

P19

Wireless Relay Box (BDR91)

Central
Controller
If you are NOT following
GUIDED CONFIGURATION
follow these steps on your
Central Controller display
first:
1. Press and hold 'Settings'
for 3 seconds
2. Press the green tick
3. Press SYSTEM DEVICES
4. Press the button next to
'Boiler Demand'
5. Press BOILER RELAY or
OPENTHERM BRIDGE
evohome Installation Guide
Power up and bind a Wireless Relay Box
(BDR91) or OpenTherm Bridge to control
a boiler
Make sure the Wireless Relay Box (BDR91) or
OpenTherm Bridge is wired to the boiler and
powered up.
To bind a Relay Box or OpenTherm Bridge
Press and hold the button for 15 seconds (until the red
1
LED blinks rapidly) to clear any previous binding data
Press and hold the button again for 5 seconds
2
(until the red LED blinks slowly)
On the Central Controller press the green bind button
3
You should receive a SUCCESS message on the
4
Central Controller (if not go back and re-bind)
1
15 SEC
2
HOlD HOlD
5 SEC