Cisco 575 LRE CPE Installation Manual page 34

Installing the CPE On a Wall
Figure 2-3
Screw
Peel the adhesive strip off the bottom of the screw template.
Step 3
Step 4 Attach the screw template to the wall.
Step 5 Use a 1/44-inch bit to drill a 1/2-inch-deep hole in the two screw template slots.
(Optional) If you wish to attach the cable lock after the cables are installed, drill
Step 6
a 1/2-inch-deep hole in the screw template hole. For more information, see the
"Attaching the Cable Lock" section on page
Insert two screws in the slots on the screw template, and tighten until they touch
Step 7
the top of the screw template.
Step 8 Remove the screw template from the wall.
Slide the CPE onto the screws until it locks in place. (See
Step 9
Cisco 575 LRE CPE Hardware Installation Guide
2-10
Installing the Mounting Screws On a Wall
Screw
Screw
template
Cable
lock hole
Chapter 2
2-16.
Figure 2-4.)
Installation
78-11469-01