Cisco 575 LRE CPE Installation Manual page 20

Features
The CPE has the following features:
•
•
•
•
Note
•
•
If additional telephone services such as voice or ISDN traffic will be carried on
the same telephone lines, a plain old telephone service (POTS) splitter can be
installed to separate LRE traffic from other telephone services. The splitter routes
the high-frequency LRE data to the switch and the low-frequency telephone
services to the private branch exchange (PBX) switch or public-switched
telephone network (PSTN).
In a typical installation, CPEs are installed in rooms of a multidwelling tenant
building. The CPE data rates and profile settings are controlled by a
Catalyst 2912 LRE XL or 2924 LRE XL switch.
installation.
Cisco 575 LRE CPE Hardware Installation Guide
1-2
IEEE 802.3 10BASE-T compliance
Autonegotiating 10/100BASE-T Ethernet port
Status LEDs showing Ethernet activity and LRE link status
Data rates of up to 15 Mbps at distances of up to 4921 feet (1500 meters)
Data rates are reduced for longer distances. Data rates are configured
through a Catalyst 2912 LRE XL or 2924 LRE XL switch. Refer to the
Catalyst 2900 Series XL Hardware Installation Guide and the
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software
Configuration Guide, for more information.
Can be co-located with standard asynchronous digital subscriber line (ADSL)
or VDSL equipment
Contains a splitter that allows regular telephone services, such as voice or
integrated services digital network (ISDN), to travel on the same lines as LRE
traffic
Chapter 1
Figure 1-1 shows a typical LRE
78-11469-01
Overview