Mc9190-G Configuration; Dhcp Server Configuration; Cradle Configuration - Motorola MC9190-G Integrator Manual

•
The ability to disable WLAN connection on the device to ensure synchronization is performed via dock.
•
Management of multiple connection types without losing settings.
To install iDockIt on the MC9190-G download the latest version of the iDockIt software from
http://www.supportcentral.motorola.com to the host computer. Follow the instructions provided with the iDockIt
software to install iDockIt onto the MC9190-G.
Refer to Appendix B, Using iDockIt

MC9190-G Configuration

Inserting the MC9190-G into the cradle provides direct-connect Remote Access Service (RAS) service. Configure
each MC9190-G for use with the cradle, just as any remote client would be configured to connect to an Internet
Service Provider (ISP). The computer comm port setting was set to USB during the iDockIt installation procedure.

DHCP Server Configuration

If you use a DHCP server to distribute IP addresses and other network parameters, the server setup should include
the following:
•
IP address pool (1 or 5 IP address per cradle)
•
Router/gateway address
•
One or more DNS server addresses
•
One or more WINS server addresses
•
Subnet mask.

Cradle Configuration

The MobileDox Cradle Manager allows you to setup the Device IP Address and modify cradle settings. See
Installing MobileDox Cradle Manager on page 2-12
Figure 2-7 on page 2-10 for instructions on Four Slot Ethernet cradle connections.
Setting the Device IP Address
By default, the cradle uses DHCP to obtain its IP address. However, if DHCP fails, the Cradle Manager can assign
an IP address.
NOTE This is used if the cradle is connected to the network, but fails to appear in MobileDox. Enter the hardware
device (MAC) address to locate the cradle and assign it a new IP address.
To set the IP address:
Launch the MobileDox Cradle Manager on the host computer.
1.
Click >
2. File Set IP Address of Unlisted Device
for instructions on configuring and using iDockIt.
for instructions to download and install the software. See
. The Set IP Address window appears:
Accessories 2 - 13