Cisco Small Business Pro SPA9000 Administration Manual page 231

SPA9000 Field Reference
Voice tab
SPA9000 Voice System Administration Guide
Downloaded from www.Manualslib.com
Voice tab > Regional page
Ring and Call Waiting Tone Spec section
Ring Waveform
Ring Frequency
Ring Voltage
CWT Frequency
Voice tab > Regional page
Control Timer Values (sec) section
Hook Flash Timer Min
Hook Flash Timer Max
Callee On Hook Delay
Reorder Delay
Call Back Expires
manuals search engine
Waveform for the ringing signal: Sinusoid or Trapezoid.
Default: Trapezoid
Frequency of the ringing signal. Valid values are 10–100 (Hz).
Default: 0
Ringing voltage. 60–90 (V).
Default: 85
Frequency script of the call waiting tone. All distinctive CWTs
are based on this tone.
Default: 440@-10
Minimum on-hook time before off-hook qualifies as hook-
flash. Less than this the on-hook event is ignored. Range: 0. 1 –
0.4 seconds.
Default: .1
Maximum on-hook time before off-hook qualifies as hook-
flash. More than this the on-hook event is treated as on-hook
(no hook-flash event). Range: 0.4–1.6 seconds.
Default: .9
Phone must be on-hook for at this time in sec before the
SPA9000 tears down the current inbound call. It does not
apply to outbound calls. Range: 0–255 seconds.
Default: 0
Delay after far end hangs up before reorder tone is played. 0
= plays immediately, inf = never plays. Range: 0–255
seconds.
Default: 5
Expiration time in seconds of a call back activation. Range: 0–
65535 seconds.
Default: 1800
B
229