Single Line Telephones, Analog 500/2500 Sets - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

Single Line Telephones, Analog 500/2500 Sets

The system is compatible with 500 type (Dial Pulse) and 2500 type (DTMF) analog single line

telephones (SLTs). You can install single line telephones as On-Premise or Off-Premise extensions.

Single line telephone users can dial codes to access many of the features available to multiline terminal

users. With single line telephones, you can have your system simulate PBX operation.

There are 320 single line telephones available (note that this number may be restricted due to system

power requirements).

When installing single line telephones you must have:

A port on an LCA blade for each single line telephone installed.

If you have 2500 sets, at least one block reserved on the CD-CP00-US for analog extension DTMF

DTMF Dial Out Timer Added

A program is added for DTMF dialing, Program 20-03-07 : System Options for Single Line

Trunk Call Dial Forced Sending Start Time (Forced Dial). When Program 20-03-03 :

System Options for Single Line Telephones – SLT DTMF Dial to Trunk Lines is set to 0 (receive all digits

before sending), the system follows the timer in Program 20-03-04 and Program 20-03-07.

The timer in Program 20-03-04 System Options for Single Line Telephones – Dial Sending Start Time

for SLT or ARS resets when the user dials another digit.

The timer in Program 20-03-07 System Options for Single Line Telephones – Trunk Call Dial Forced

Sending Start Time (Forced Dial) does not reset when a digit is dialed. The user must finish dialing all

the digits before this time expires (entries: 0~64800 seconds, default: 0).

Dial Pulse (500 type) single line telephones cannot access any feature that requires the

user to dial

A single line telephone can initiate an Internal Zone page, but cannot receive an Internal

When a Ring Group call rings a single line station, the BLF indication shows busy.

Stutter Dial Tone is supported to Single Line Telephones for Voice Mail Message Waiting.

Single Line Telephones, Analog 500/2500 Sets

Table of Contents