NEC Univerge SV8100 Features And Specifications Manual page 1388

Issue 11.0
E911 Compatibility
ISDN Compatibility
Multiple Trunk Types
Station Message Detail Recording
T1 Trunking (with ANI/DNIS Compatibility)
Traffic Reports
Trunk Groups
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
14-01-06 Basic Trunk Data Setup – SMDR
Printout
15-01-03 Basic Extension Data Setup –
SMDR Printout
35-01-01 SMDR Options – Output Port
Type
2 - 1356
Description/Comments
Have the system Include (1) or
Exclude (0) the trunk you are
programming from the SMDR
printout. Refer to Program 35-01
and 35-02 for SMDR printout
options.
For each extension, enter 1 if an
extension call should appear on
the SMDR report. Enter 0 for the
extension if the calls should not
appear.
Specify the type of connection
used for SMDR. The baud rate for
the COM port should be set in
Program 15-02-19.
UNIVERGE SV8100
Assigned Data
0 = No Print Out
1 = Prints Out
(default = 0)
0 = Do not print on
SMDR report
1 = Include on
SMDR report
(default = 1)
0 = None
3 = LAN
4 = CTA/CTU
(default = 0)
SMB8000 Communications Analyst
Level
1 2 3


