Wipe Disk; Font Sharpening; Require Standby - Dell 5535dn Service Manual

The entire process is complete when the progress bar appears completely shaded and the percentage
indicator shows 100%. After completion, the panel returns to Disk Encryption.

Wipe Disk

This setting provides you with a tool for erasing the contents of a disk.
Warning: Wipe Disk removes a disk's data in such a way that it cannot be recovered.
To change this setting:
1. Touch
Note: If an advanced password has been established, you must enter this password in order to change
the setting. If no advanced password exists, you can establish one by using the keyboard that appears on
the LCD.
2. Touch
Contents will be lost. Continue? appears on the touchscreen.
3. Touch Back to return to Configuration Menu.
4. Touch Yes to continue, or touch No to exit.

Font Sharpening

This setting allows a user to set a text point size below which the high frequency screens are used when
printing font data. For example, at the default 24, all text in font sizes 24 and less will use the high frequency
screens. The values for this setting range from 0 to 150, and the default value is 24. This setting affects
PostScript, PCL, and XL.
To change this setting:
1. Touch
2. Touch
3. Touch Submit to save the change.
Touch Back to cancel and return to the Configuration Menu.
This function is not supported when the device generates output at 600 dpi resolution.

Require Standby

This setting determines if the Standby Mode is On or Off. The default is On.
If Standby Mode is On, the printer begins functioning in Standby Mode when it remains idle for an amount of
time. The Standby Mode enables the printer:
•
To consume less energy than when operating in normal mode but not as little as when operating in Power
Saver
•
To return to the Ready state more quickly than when operating in Power Saver
To change this setting:
1. Touch
2. Touch Submit to save the change.
Touch Back to cancel and return to the Configuration Menu.
to select Wipe Disk from Configuration Menu.
to select Wipe disk now.
to select Font Sharpening from the Configuration Menu.
to increase the value or
to select Require Standby from the Configuration Menu.
to decrease the value.
3-39
Diagnostic aids