Min Copy Memory; Format Fax Storage; Fax Storage Location; Adf Edge Erase - Dell 5535dn Service Manual

Min Copy Memory

1. Touch
The panel displays the setting's name in the header and
row.
2. Touch or
For example, the values may be 25 MB, 35 MB, 50 MB, and 100 MB. The default is 25 MB. Values will only
be displayed if the amount of installed DRAM is at least twice the amount of the value, that is, at least
200 MB of installed DRAM is required to display the 100 MB selection.
3. Touch Submit to save your change.
Touch Back to exit without changing the value.

NumPad Job Assist

1. Touch
The panel displays the setting's name in the header and
row.
2. Touch or
The settings are On and OFF.
3. Touch Submit to save your change.
Touch Back to exit without changing the value.

Format Fax Storage

This setting enables you to format the non-volatile storage used for storing faxes.
To change this setting, touch
Fax Flash DO NOT POWER OFF appears on the LCD while the format operation is active.
Note: If an advanced password has been established, you must enter this password in order to change the
setting.

Fax Storage Location

To change this setting, touch
1. Touch or
The settings are Disk and NAND.
2. Touch Submit to save your change.
Touch Back to exit without changing the value.

ADF Edge Erase

The ADF Edge Erase and FB Edge Erase settings specify, in millimeters, the size of a border around the
scanned image that will be erased. For copies, the printed page will have a 2 mm no-print border. The larger of
the 2 mm no-print border and the Edge Erase setting will be used in this situation.
To change this setting:
1. Touch
The panel displays the setting's name in the header and
row.
2. Touch
The values are 0 through 6. The default is 3.
3-34
Service Manual
to select Min Copy Memory from the Configuration Menu.
to change the setting.
to select NumPad Job Assist from the Configuration Menu.
to change the setting.
to select Format Fax Storage from the Configuration Menu. Formatting
to select Fax Storage Location from the Configuration Menu.
to change the setting.
to select ADF Edge Erase from the Configuration Menu.
to increase the value or
[setting's current value]
[setting's current value]
[setting's current value]
to decrease the value.
below the header
below the header
below the header