Draytek Vigor IPPBX 2820 Series User Manual page 223

Src IP End
Dest IP Start
Dest IP End
Dest Port Start
Dest Port End
Move UP/Move Down
Click Index 1 to access into the following page for configuring load-balance policy.
Enable
Protocol
Binding WAN
interface
Src IP Start
Src IP End
VigorIPPBX 2820 Series User's Guide
Displays the IP address for the end of the source IP.
Displays the IP address for the start of the destination IP.
Displays the IP address for the end of the destination IP.
Displays the IP address for the start of the destination port.
Displays the IP address for the end of the destination port.
Use Up or Down link to move the order of the policy.
Check this box to enable this policy.
Use the drop-down menu to choose a proper protocol for the
WAN interface.
Choose the WAN interface (WAN1 or WAN2) for binding.
Auto failover to other WAN – Check this button to lead the
data passing through other WAN automatically when the
selected WAN interface is disconnected.
Type the source IP start for the specified WAN interface.
Type the source IP end for the specified WAN interface. If this
field is blank, it means that all the source IPs inside the LAN
215