User Deletion; Keypad Emergency Conditions - Honeywell OMNI 624 Installation And Setup Manual

OMNI624 Installation and Setup Guide
where:
MASTER USER
USER NO.
1, 2, or 4
To exit this mode, press [✱].
User code programming can ONLY be performed while the system is DISARMED.

User Deletion

User codes (02–32) can be deleted from any keypad. Once deleted, their values are null.
TO DELETE USERS:
[CODE] + MASTER CODE + USER NO. + [#]
where:
[CODE]
MASTER CODE
USER NO.
[#]

Keypad Emergency Conditions

The system is capable of transmitting four keypad auxiliary conditions as follows:
CONDITION
PANIC
FIRE
AUXILIARY
DURESS
The keypads have additional keys dedicated for emergency conditions. These can be activated by
pressing both keys at the same time (see "Keypads" in this section).
Audible Panic, Fire, and Audible Auxiliary can be RESET BY ENTERING ANY VALID USER CODE.
5–10
User with authority level 1 or 2.
The user that will be assigned access to other partitions.
Select 1 or 2 to assign access to a partition to that user.
Select 4 to enable open/close paging report for that user.
[CODE] button on keypad.
Master User code.
Desired user number being deleted (02–32).
[#] button.
KEYSTROKES CS REPORT ENABLE
# & ✱ (at the same
Submode 2, Question
time) 38, L1, L2
7 & 9 (at the same Submode 2, Question
time) 40, L1, L2
1 & 3 (at the same Submode 2, Question
time) 40, L3, L4
User code #31 and Submode 2, Question
32 37, L1, L2
OPTIONS
(aud./silent; arm beeps; relays)
See Submode 1, Question 27,
L1, L2
Immediate and unabortable.
See Submode 1, Question 26,
L3, L4
See Submode 1, Question 26,
L1, L2
See Submode 1, Question 13,
L1