Keypad Sounder - Honeywell OMNI 624 Installation And Setup Manual

Fbii security system
Hide thumbs Also See for OMNI 624:
Table of Contents

Advertisement

Slow Blink
Indicates Installer programming mode
Fast Blink
Alarm Memory mode
7)
SUPER LED
This LED/display indicates the status of supervised devices as follows:
Slow Blink
Bell supervision
Fast Blink
Zone tamper
8)
[STAY] BUTTON
The [STAY] button arms the system, excluding zones programmed as Stay/AutoStay zones. This
provides exterior protection of the premises while allowing full access throughout the interior.
9)
[BYPASS] BUTTON
The [BYPASS] button is used to temporarily exclude protection to a specific zone(s).
10)
[INSTANT] BUTTON
If pressed, the [INSTANT] button allows arming the system in the INSTANT mode; with the
[STAY] button, it enables arming the system in the STAY/INSTANT mode.
NOTE: INSTANT mode is enabled in Question 14, Location 1.
11)
[CODE] BUTTON
The [CODE] button is used to allow entry into the Installer programming mode and permits the
entry of user codes.
12)
KEYPAD AUXILIARY KEYS
Pressing the auxiliary keys (XK108: two keys labeled P, A, or F at the same time; OMNI-LCD/
OMNI-LCD-US/XK7LC/OMNI-KP/OMNI-KP-US: 1/3, 7/9, ✱/#) initiates a CS transmission, if
programmed, of programmed functions (e.g., PANIC, AUXILIARY, or FIRE), and causes
annunciation of the keypad sounder and turns on the bell output. The programmed functions are
defined in Programming Submode 1, Questions 26 and 27.
See "Keypad Emergency Conditions" in this section for alternate auxiliary keys.

Keypad Sounder

The sounder (or loudspeaker) housed inside the keypad emits (annunciates) sounds according to the
condition of the security system.
Enabling keypad sounder:
XK7LC: Set the 4th DIP switch on the back of the keypad (remove cover) on or off to turn sounder
on/off.
OMNI-KP and OMNI-KP-US: Press the BYPASS and CODE keys at the same time and hold down for
two seconds until you hear a beep. Press any key (except the [✱] key) to toggle the sounder on or off.
0 = Sounder off
1 = Sounder on
Press the [✱] key to exit the sounder menu.
Section 5. System Operation
5–3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents