Honeywell OMNI 624 Installation And Setup Manual page 75

L1-L2 Auto- Audible Arm
Entry arm Warning
0
✔
1
✔ ✔
3
✔
5
✔ ✔
7
✔
9
✔ ✔
B
✔
D
✔ ✔
F
NOTE: All auto-arm modes will force-arm the system. This means any open zones at the time of auto-
arming will be bypassed. To report these bypassed zones, program a bypass code in Programming
Submode 2, Question 44, L1.
U L
Must be programmed as "0" for UL installations.
Q 28, L4 Up and About Enables
L4 Up and About
Entry Part. 1
0
✔
1
2
✔
3
QUESTIONS 29–30 AUTO-ARM TIMES
These questions set the auto-arming time for each partition.
L1/L2: Enter hour 00–23 by entering the first digit of the hour (0–2) in L1 and the second digit (0–9) of
the hour in L2. (00 = 12 midnight)
L3/L4: Enter minute 00–59 by entering the first digit of the minute (0–5) in L3 and the second digit (0–
9) of the minute in L4.
For example, to set an auto-arm time of 11:35pm, enter 2 in L1 and 3 in L2, then enter 3 in L3 and 5 in
L4.
U L
Must be disabled for UL installations.
QUESTION 29 AUTO-ARM TIME PARTITION 1
QUESTION 30 AUTO-ARM TIME PARTITION 2
Instant Stay
Arming Arming Auto-arm: Arms the system in AWAY mode at time
specified in Programming Submode 1, Questions 29
and 30 for partitions 1 and 2, respectively.
Audible Arm Warning: If enabled, allows an audible
✔
keypad sound to warn of auto-arming.
✔
Instant Auto-arming: Arms the system with entry
✔
delay disabled.
✔
✔ ✔
Stay Auto-arming: Arms the system in STAY mode.
✔ ✔
Up and About
Up and About: If no controlled zone is violated within a 24-
Part. 2
hour period (beginning at midnight), a signal is sent to the
central station. This can serve as a safety feature for elderly,
✔
infirm, or disabled persons.
✔
Section 6. System Programming
L1 L2 L3
Hours (00-23) Minutes (00-59)
L1 L2 L3
Hours (00-23) Minutes (00-59)
L4
L4
6–37