Table of Contents
Advertisement
OMNI624 Installation and Setup Guide
1 and central station 2 until contact is established or the maximum number of dialing attempts (see
Question 11, Location 3) expires.
Dual: Events will be sent to both central station phone numbers.
Split Reporting: If split reporting is enabled, then all reports other than openings and closings will be
sent to CS#1. Openings/closings will be transmitted to CS#2.
Dialer Disable: This option will turn OFF the digital dialer, making the control a local panel. The
Dialer Disable selection shall not be selected for UL installations.
Report Stay Bypass: This option specifies that bypasses will be transmitted upon Stay or Auto Stay
arming. If this option is selected, then bypasses will be transmitted for each Stay/Auto Stay zone that
has been bypassed with STAY or Auto Stay arming.
NOTE: Bypasses will be transmitted only if there is a bypass code defined (see Submode 2, Question
44, L1).
First to Open/Last to Close: If selected, open/close reports are only sent after all partitions are
armed/disarmed. The open report will indicate only the partition that first disarmed the system. The
close report will indicate only the partition that was the last to arm the system (thus causing all
partitions to be armed).
Q 11, L2 Restore Reporting – Enter the digit for the type of Restore reports to be sent. Program the
actual Restore report codes in Submode 2, Question 47.
L2
Supervision
Entry
Restore
0
✔
1
2
✔
3
4
✔
5
6
✔
7
Q 11, L3 CS Dialer Attempts – This option selects the number of times the communicator will attempt
to dial both CS receivers. If CS #2 is not programmed, then this option determines the dialer attempts
to CS #1. Enter the number of attempts, 1–15.
NOTE: This is valid for all CS receiver formats. Enter a digit from the table that follows.
L3
Dialer
Entry
Attempts
0
1
1
1
2
2
3
3
4
4
5
5
6
6
7
7
6–16
Tamper
RF Low Bat.
Restore
Restore
✔
✔
✔
✔
✔
✔
✔
✔
L3
Dialer
Entry
Attempts
8
8
9
9
A
10
B
11
C
12
D
13
E
14
15
F
For UL installations you must select a
U L
value between 5 and 10.
Hide quick links:
Advertisement
Table of Contents
