Honeywell OMNI 624 Installation And Setup Manual page 45

INSTALLER MODE 4 (SYSTEM LOG VIEW)
The system retains history of the past 128 events (alarms, troubles, openings, closings, bypasses, etc.).
Upon entry to the system log view, LCD-based keypads show the events for the entire system, based on
the options programmed in Question 17, Locations 1–3. Additionally, the programmed time and date
display options are followed. This means the time may be 24-hour or AM/PM format, and the date may
have either the day or month displayed first. When the log is viewed through the quick command, the
clear log function is blocked. This mode is available only on LCD keypads.
Pressing either the [STAY] or the [✱] key exits this mode.
Pressing the [#] key advances to the next valid entry.
Pressing the [CODE] key backs up to the previous entry.
Pressing the [BYPASS] key clears the system log.
LCD keypads display events as:
where:
Line 1: event number (L001–L128), event display, zone no. (01–24), or user no. (01–32)
Line 2: date, time, partition (1–4) if a partitioned system
Event Displays
Event
System Troubles
System AC Loss
System Low Batt
Comm. Fail
CS Test
System Download
Phone Fail
Special Alarms
Keypad ✱ & #
Keypad 7 & 9
Keypad 1 & 3
Keypad Duress
Keypad Tamper
INSTALLER MODE 5 (SYSTEM DEFAULT)
This mode can initiate a system default. The system will then revert to factory-programmed values and
go through the reset sequence and the warm-up time sequence.
INSTALLER MODE 6 (CLEAR TAMPER FAULTS)
This mode clears all tamper displays in all partitions for double balanced and RF zones that have
restored, and is an Installer reset function.
Display Event
Special Arming
Lnnn AC Loss
Quick Arm
Lnnn Batt. Fail
Quick Force Arm
Lnnn Comm. Fail
Stay Key Arm
Lnnn CS Test
Remote Arm
Lnnn Downloaded
Auto-arm
Lnnn Phone Fail
Instant Arms Away
Other Events
Lnnn Keypad ✱ & #
Alarms
Lnnn Keypad 7 & 9
Troubles
Lnnn Keypad 1 & 3
Zone Low Battery
Lnnn Duress
Zone Supervision
Lnnn Key Tamper
Zone Bypass
Zone Tamper
Opening
Closing
Section 6. System Programming
L 001 ALARM ZN 01
20 APR, 10:38
Display
Lnnn Quick Armed
Lnnn Forced Arm
Lnnn Quick Armed
Lnnn Remote Arm
Lnnn Auto-armed
Lnnn Quick Armed
Lnnn Alarm Zn xx
Lnnn Troub Zn xx
Lnnn Lo Bat Zn xx
Lnnn Super Zn xx
Lnnn Bypas Zn xx
Lnnn Tampr Zn xx
Lnnn Opn User xx
Lnnn Clo User xx
P1
6–7