Daylight Saving Time Examples; Selecting A Display Language - Cisco SPA303 Administration Manual

Configuring Regional Parameters and Supplementary Services
Localizing Your IP Phone
NOTE
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
save-time
The value is the number of hours, minutes, and/or seconds to add to the
current time during DST. The
minus (-) sign to indicate addition or subtraction.

Daylight Saving Time Examples

The following example configures daylight saving time for the U.S, adding one hour
starting at midnight on the first Sunday in April and ending at midnight on the last
Sunday of October; add 1 hour (USA, North America):
start=4/1/7/0:0:0;end=10/31/7/0:0:0;save=1
start=4/1/7;end=10/-1/7;save=1
start=4/1/7/0;end=10/-1/7/0;save=1
The following example configures daylight saving time for Egypt, starting at
midnight on the last Sunday in April and ending at midnight on the last Sunday of
September:
start=4/-1/7;end=9/-1/7;save=1 (Egypt)
The following example configures daylight saving time for New Zealand, starting
at midnight on the first Sunday of October and ending at midnight on the third
Sunday of March. This only applies to countries that recognize daylight saving
time.
start=10/1/7;3/22/7;save=1 (New Zealand)
The following example reflects the new change starting March 2007. DST starts on
the second Sunday in March and ends on the first Sunday in November:
start=3/8/7/02:0:0;end=11/1/7/02:0:0;save=1

Selecting a Display Language

This section describes how to localize the Cisco SPA300 and Cisco SPA500
Series IP Phone display language. You can define up to nine languages, in addition
to English, to be available and host the dictionaries for each of the languages on
the HTTP or TFTP provisioning server. Language support follows Cisco dictionary
principles.
The WIP310 does not support localization; however, daylight saving time
adjustment is supported.
Use the Language Selection parameter to select the phone's default display
language. The value must match one of the languages supported by the dictionary
server. The script (dx value) is as follows:
save-time
value can be preceded by a plus (+) or
7
193