Vlan Settings - Cisco SPA303 Administration Manual

Cisco SPA IP Phone Field Reference
System Tab
NOTE
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Parameter
DNS Query Mode
Syslog Server
Debug Server
Debug Level
Primary NTP Server
Secondary NTP Server
Enable Bonjour (SPA525G/
525G2 only)

VLAN Settings

Not applicable to the WIP310.
Parameter
Enable VLAN
Description
Do parallel or sequential DNS Query. With parallel DNS
query mode, the IP phone sends the same request to
all the DNS servers at the same time when doing a
DNS lookup, the first incoming reply is accepted by the
IP phone.
Defaults to parallel.
Specify the syslog server name and port. This feature
specifies the server for logging IP phone system
information and critical events. If both Debug Server
and Syslog Server are specified, Syslog messages are
also logged to the Debug Server.
The debug server name and port. This feature
specifies the server for logging IP phone debug
information. The level of detailed output depends on
the debug level parameter setting.
The debug level from 0-3. The higher the level, the
more debug information is generated. Zero (0) means
no debug information is generated. To log SIP
messages, you must set the Debug Level to at least 2.
Defaults to 0.
IP address or name of primary NTP server.
IP address or name of secondary NTP server.
Enable Bonjour networking that is used by Office
Manager and Cisco Configuration Assistant to discover
the Cisco IP phones. Choose yes to enable or no to
disable.
Description
Choose Yes to enable VLAN. Choose no to disable.
B
237