Getting Started
Using the Web-Based Configuration Utility
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
To perform these tasks...
View phone, extension, and line/call information,
including:
•
DHCP, current IP address, DNS addresses
•
Software and hardware versions
•
Broadcast, RTP, and SIP information
•
Registration state
•
Packets sent, received, lost, and other
information
Configure system-level parameters, including
network and debug parameters. To:
•
Enable the configuration utility and
administrator access
•
Set the Internet connection type to DHCP
•
Configure the syslog and debug servers
•
Enable VLAN and CDP
Configure parameters to adjust SIP stack and
protocols. To enable:
•
CTI
•
SIP-B
•
STUN
Configure provisioning parameters. To:
•
Enable remote provisioning
•
Enable firmware upgrades
•
Set general purpose parameters
In the configuration utility, click
the ...
Info tab
See
"Viewing Phone
Information" section on
page
29.
System tab
See
Chapter 5, "Configuring
Security, Quality, and Network
Features."
SIP tab
See
Chapter 4, "Configuring
SIP, SPCP, and NAT."
Provisioning tab
The
Provisioning
tab is viewable
by Admin logins only.
See
Chapter 6, "Provisioning
Basics."
For additional
information about provisioning,
Cisco Small Business IP
see the
Telephony Devices Provisioning
Guide
(for Cisco service
providers).
1
26