Advertisement
side of the blade with the top surface
of the turn base using the triangular
rule, try-square, etc. by turning the
hex bolt (A) clockwise. Then tighten
the lever securely.
Make sure that the pointer on the
turn base indicates 0" on the bevel
scale on the arm . If the pointer does
not indicate 0", loosen the screw
securing the pointer and adjust the
pointer.
b) 45' bevel angle
Adjust 45" bevel angle after perform-
ing 0" bevel angle adjustment. To
adjust 45" bevel angle, loosen the
lever and tilt the blade to the left fully.
Make sure that the pointer on the
arm indicates 45" on the bevel scale
on the arm. If the pointer does not
indicate 45"", turn the right hex bolt
(B)
at the rear of the turn base with
the socket wrench until the pointer
indicates 45O.indicates 45".
21
Advertisement
