Table of Contents
Advertisement
HULL
HOOD
HANDLEBAR
SERVICE POINTS
Handlebar inspection
1. Inspect:
• Handlebar
Bends/cracks/damage → Replace.
Handlebar switch inspection
Refer to "STARTING SYSTEM" in
Chapter 7.
Handlebar assembly installation
1. Install:
• Handlebar switch lead 1
NOTE:
Be sure to leave some slack in the handlebar
switch lead 1 in the area a shown in the illus-
tration.
2. Install:
• Upper handlebar holder 1
NOTE:
The upper handlebar holder should be installed
with the punch mark a facing forward.
CAUTION:
Clearance b should be narrower than
clearance c.
Handlebar holder bolt:
20 N • m (2.0 kgf • m, 14 ft • lb)
LOCTITE 572
Reference clearance:
b: 1.5 mm (0.06 in)
c: 3.5 mm (0.14 in)
8-6
E
Advertisement
Chapters
Table of Contents
