Table of Contents
Advertisement
JET
PUMP
IMPELLER DUCT AND DRIVE SHAFT
a
5. Install:
• Front bearing
NOTE:
Press the spacer and the front bearing using a
pipe that is more than 60 mm (2.36 in) long
and that has an inner diameter more than 26
mm (1.02 in).
6. Install:
• Drive shaft (with front bearing spacer
and rear bearing)
Distance a:
11.7 ± 0.2 mm (0.46 ± 0.01 in)
NOTE:
Press the rear bearing using a washer or pipe
that has an outer diameter of 50 mm (1.97 in)
and an inner diameter of 33 mm (1.30 in).
7. Add:
• EPNOC grease AP #0 (into the cap)
Quantity:
20 g (0.7 oz)
6-13
E
Advertisement
Chapters
Table of Contents
