Table of Contents
Advertisement
INSP
ADJ
2
1
FUEL SYSTEM/POWER UNIT
Water separator inspection
1. Inspect:
• Water separator 1
Water accumulation → Drain.
NOTE:
To drain the water, remove the drain plug.
POWER UNIT
Valve clearance adjustment
The following procedure applies to all of the
valves.
NOTE:
• Valve clearance adjustment should be made
on a cold engine, at room temperature.
• When the valve clearance is to be measured
or adjusted, the piston must be at top dead
center (TDC) of the compression stroke.
1. Remove:
• Ignition coils
• Spark plugs
• Cylinder head cover
• Cylinder head cover gasket
Refer to "CAMSHAFTS" in Chapter 5.
2. Install:
• Dial gauge needle
• Dial gauge stand 1
(into spark plug hole #1)
• Dial gauge 2
Dial gauge stand:
90890-06583
Dial gauge needle:
90890-06584
Dial gauge stand set:
YB-06585/90890-06585
Dial indicator gauge:
YU-03097
Dial gauge set:
90890-01252
3-8
E
Advertisement
Chapters
Table of Contents
