Verifying Package Contents For The Cisco Ipvc 3540 Pri Gateway; Installing The Cisco Ipvc 3521 Bri Gateway In A Rack - Cisco 3521 Administrator's Manual

Installing the Cisco IPVC 3521 BRI Gateway in a Rack

•

Verifying Package Contents for the Cisco IPVC 3540 PRI Gateway

Your Cisco IPVC 3540 PRI Gateway module package contains the following:
•
•
•
•
•
•

Installing the Cisco IPVC 3521 BRI Gateway in a Rack

You can install the Cisco IPVC 3521 BRI Gateway in a 19-inch rack. The mounting kit supplied with
the gateway includes two brackets for mounting the unit on a rack. This section describes how to install
the mounting brackets.
Procedure
Place the unit the right way up on a hard flat surface, with the front panel facing you.
Step 1
Position a mounting bracket over the mounting holes on one side of the unit (see
Step 2
Figure 2-1
Pass the three screws through the washers and bracket holes into the gateway, and tighten them securely
Step 3
with a screwdriver.
Repeat Steps 2 and 3 for the other side of the gateway.
Step 4
Insert the unit into the 19-inch rack and secure.
Step 5
Two screws are needed for each side. These screws are not provided.
Note
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
2-4
Cisco Information Packet
Cisco IPVC 3540 PRI Gateway module
Cisco IPVC 3540 Rear Transition Module for the PRI gateway
Terminal cable
Regulatory Compliance and Safety Information for Cisco IPVC 3540 Product Family
Cisco IPVC Software CD-ROM
Cisco Information Package
Mounting Bracket Installation
Make sure that the air vents in the sides of the unit are not blocked.
Chapter 2 Installing the Cisco IPVC 3500 Series Gateway
Figure 2-1).
OL-7995-01