Verifying The Device Operations; Verifying Hardware Status - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

6.1 Verifying the Device Operations

This chapter describes the management of the device.
Hardware status
System status
Log messages

6.1.1 Verifying Hardware Status

Verify the status of hardware by entering the
administrator EXEC mode. The following example shows the information that is displayed when the
command is entered.
xg# show system status
System Status Information 2007/01/25-12:16:19
==============================================
[Temperature]
Internal
[Power Supply]
PWR-0 (AC)
PWR-1 (AC)
[Voltage]
Voltage
[Fan]
Rear Fan-0
Rear Fan-1
PWR-0 Fan
PWR-1 Fan
[XFP]
port 1 (VENDER-NAME.
port 2 (VENDER-NAME.
port 3 (VENDER-NAME.
port 4 (VENDER-NAME.
port 5 (VENDER-NAME.
port 6 (VENDER-NAME.
port 7 (VENDER-NAME.
port 8 (VENDER-NAME.
port 9 (VENDER-NAME.
port 10 (VENDER-NAME.
port 11 (VENDER-NAME.
port 12 (VENDER-NAME.
port 13 (VENDER-NAME.
port 14 (VENDER-NAME.
port 15 (VENDER-NAME.
port 16 (VENDER-NAME.
port 17 (VENDER-NAME.
port 18 (VENDER-NAME.
port 19 (VENDER-NAME.
port 20 (VENDER-NAME.
"show system
: good
: good
: good
: good
: good (normal-speed)
: good (normal-speed)
: good
: good
:S ) : good
:L ) : good
:S ) : good
:L ) : good
:S ) : good
:L ) : good
:S ) : good
:L ) : good
:S ) : good
:L ) : good
:S ) : good
:L ) : good
:S ) : good
:L ) : good
:S ) : good
:L ) : good
:S ) : good
:L ) : good
:S ) : good
:L ) : good
265/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
status" command in the operator EXEC mode or in the
"show system status"