XG2000 series User's Guide
5.10.15 multicast-forwarding
Function
Sets the forwarding method for multicast frames.
Use the no form to return to the default setup.
Prompt
xg(config)# or xg(config-agg)#
Command syntax
multicast-forwarding { forward-all | forward-unregistered-mac |
filter-unregistered-mac }
no multicast-forwarding
Parameter
{ forward-all | forward-unregistered-mac | filter-unregistered-mac }
Specifies the forwarding method for multicast frames.
−
−
−
Command type
Configuration command
Default
forward-all
Example
Enter the interface edit mode using switch ports 1 to 3, then set them to the unregistered multicast forwarding mode.
xg(config)# interface port range 1 3
xg(config-if)# multicast-forwarding forward-unregistered-mac
Forward-all
All multicast frames will be forwarded (flooded).
Forward-unregistered-mac
Multicast addresses yet to be registered in the static MAC address table, and multicast
addresses registered will be forwarded (flooded). Multicast addresses registered as
non-member ports will be filtered.
Filter-unregistered-mac
Only Multicast addresses registered as member ports in the static MAC address table
will be forwarded.
All Rights Reserved, Copyright (C) PFU LIMITED 2009
155/315