Show Bridge Mac-Address-Table - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

5.7.3 show bridge mac-address-table

Function
Displays the MAC address information registered in the MAC address table.
Prompt
xg> or xg#
Command syntax
show bridge mac-address-table [ { static | dynamic | igmp-snooping | port <1-20> | agg-port <1-10> |
vlan <1-4094> } ]
Parameter
static
Displays only static MAC addresses.
dynamic
Displays only dynamic MAC addresses.
igmp-snooping
Displays MAC addresses registered in IGMP snooping.
port <1-20>
Specifies the port number of the switch to display.
agg-port <1-10>
Specifies the aggregation group number of the switch to display.
Vlan <1-4094>
Specifies the vlan number of the switch to display.
When the parameters are omitted, all MAC addresses will be displayed.
Command type
Operation management commands
Output form
xg# show bridge mac-address-table
Mac Address Table Information
Static Mac-address Table
------------------------------------------------------------------------
Mac-address
-------------- -------- --------------------
0001.123a.4321 vlan-1
0002.123a.4321 vlan-1
0003.123a.4321 vlan-3
ef01.123a.4321 vlan-3
Dynamic Mac-address Table
----------------------------------------------------------------
Mac-address
-------------- -------- --------------------
0004.123a.4321 vlan-1
IGMP snooping learning group Mac-address Table
----------------------------------------------------------------
Mac-address
-------------- --------- -------------------------------------
(nothing)
================================================================
MAC addresses are sorted in the ascending order.
Mac-address
The destination MAC address is displayed.
Vlan-id
The associated VLAN ID is displayed.
When the learning mode of the MAC address table is SVL (Shared Vlan Learning), "-------"
is displayed.
Destination-port
The associated destination port number is displayed.
−
−
Message
% IGMP snooping is not enabled.
Explanation
Since Global IGMP snooping is disabled, igmp-snooping cannot be specified.
Solution
After enabling IGMP snooping, specify igmp-snooping.
Vlan-id Destination-port
port 2
port 4
filter
port 1 2 3 4 5 6 7 8
Vlan-id Destination-port
port 4
Destination-port
Vlan-id
port <1-20>
The destination port number is shown. For multicast MAC addresses, multiple port numbers
are displayed.
filter
The MAC addresses are filtered.
All Rights Reserved, Copyright (C) PFU LIMITED 2009
2007/01/22-12:12:15
122/315