XG2000 series User's Guide
5.11.2 spanning-tree
Function
Enables the Spanning Tree Protocol (STP).
Use the no form to disable Spanning Tree Protocol.
Prompt
xg(config)#
Command syntax
spanning-tree
no spanning-tree
Command type
Configuration command
Default
None
Message
% port %1$ is membership of uplink-domain %2$.
Explanation
The specified port already belongs to an uplink domain.
[[Inserted string]]%1$: specified port number
[[Inserted string]]%2$: uplink domain number
Solution
Specify a port not belonging to an uplink domain or remove the port from an uplink domain.
Note
STP cannot be used on uplink ports. STP port fast, however, is allowed on uplink ports.
Example
Enable Spanning Tree Protocol.
xg(config)# spanning-tree
161/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009