NETGEAR ProSafe WNDAP350 Reference Manual page 92

ProSafe Dual Band Wireless N Access Point WNDAP350 Reference Manual
.
Figure 4-1 DHCP server settings
3. Configure the following TCP/IP configurations for using the WNDAP350 as a DHCP Server
for wireless clients.
• DHCP Server: By default, the Dynamic Host Configuration Protocol (DHCP) server on
the AP is disabled. If you enable it, all the wireless clients associated with the AP will get
their IP addresses, subnet mask and default gateway settings automatically from the AP.
• DHCP Server VLAN ID: All the stations that are part of the configured VLAN ID will
get their IP addresses only from the AP.
• Starting IP Address: Enter the starting IP address that can be assigned from the DHCP
server on this Access Point.
• Ending IP Address: Enter the Ending IP address that can be assigned from the DHCP
server on this Access Point
• Subnet Mask: The Access Point will assign the specified subnet mask to the connected
wireless stations.
• Gateway Address: The Access Point will assign this IP address as the default gateway for
any traffic beyond the local network.
• Primary DNS Server: The Access Point will assign this IP address as the primary
Domain Name Server used by the connected wireless stations.
4-2
v2.0, April 2013
Advanced Configuration