NETGEAR ProSafe WNDAP350 Reference Manual page 70

ProSafe Dual Band Wireless N Access Point WNDAP350 Reference Manual
To set up an SNMP management interface:
1. Under the Maintenance tab, select Remote Management, and then select SNMP from the
left sidebar. The SNMP screen displays, as shown in
Figure 3-1 Configure SNMP settings
2. Enter the following information in the SNMP fields:
• SNMP: Enable SNMP to allow the SNMP network management software, such as HP
OpenView, to manage the wireless access point via SNMPv1/v2 protocol.
• Read-Only Community Name: The community string to allow the SNMP manager to
read the wireless access point's MIB objects. The default is Public.
• Read-Write Community Name: The community string to allow the SNMP manager to
read and write the wireless access point's MIB objects. The default is Private.
• Trap Community Name: The community string to allow the SNMP manager to send
traps. The default is trap.
• IP address to Receive Traps: The IP address of the SNMP manager to receive traps sent
from the wireless access point.
• Trap Port: The port number on which the SNMP Manager will receive traps. The default
is 162/UDP.
3-2
Figure 3-1
v2.0, April 2013
below:
Management