A Word On Copier Installation; Cautions - Sharp SF-1116 Operation Manual

A WORD ON COPIER INSTALLATION

Improper installation may damage the copier. Please note the following
during initial installation and whenever the copier is moved.
1. Be sure to use the rated power supply and to ground the copier.
For this copier's power supply requirements, see the name plate
located on the right hand side of the copier, below the manual
bypass.
2. Do not install the copier in areas that are:
damp or humid,
exposed to direct sunlight,
extremely dusty,
poorly ventilated,
subject to extreme temperature or humidity changes, e.g., near an
air conditioner or heater.
3. Place the copier on a firm, level surface.
4. Keep the copier at least 10 cm (4 inches) back from the wall for
proper ventilation and cooling.

CAUTIONS

1. Do not touch the photoconductive drum. Scratches or smudges
on the drum will cause dirty copies.
2. The fusing area is hot. Exercise care in this area.
2
Fusing unit
Photoconductive drum
10cm
(4 inches)