Power Save Modes - Sharp SF-1116 Operation Manual

POWER SAVE MODES

3
6
9
C
3
6
9
C
3
6
9
C
38
Setting the power save modes
The auto power save control function can be enabled or disabled as
desired using user program No. 4. If this function is disabled, the time
that elapses before the copier enters a power save mode after any
operation is made can be set manually. This time is set with user
program No. 2 for the preheat mode and user program No. 3 for the
auto power shut-off mode. If the auto power save control function is
enabled, the settings of user programs No. 2 and No. 3 will be ignored.
For these settings, see page 31.
The copier will enter first the preheat mode and then the auto power
shut-off mode when no copier operation is made.
If the time set for the preheat mode is not shorter than that for the
auto power shut-off mode, the copier will enter only the auto power
shut-off mode when the time set for the auto power shut-off mode
has elapsed.
If the auto power shut-off timer is set using user program No. 3 when
the auto power shut-off mode has been disabled (program No. 20),
the auto power shut-off mode will be automatically enabled.
It is recommended that these power save modes be enabled for
energy saving.
Copying from the preheat mode
ACC.#-C
Make desired copier selections and press the print (
button using the normal copying procedure.
When any key input is made or any other copier operation is
CA
made, the POWER SAVE (
When the print (
go out and copying will start within 10 seconds. The POWER
SAVE (
Copying from the auto power shut-off mode
ACC.#-C
1 Press the print (
The copier will exit the auto power shut-off mode and the
POWER SAVE (
CA
2 Make desired copier selections and press the print (
ACC.#-C
button using the normal copying procedure.
It will take approximately 35 seconds for the copier to start
copying. However, you can make desired settings and press the
print (
up is finished.
CA
) indicator will start to blink.
) button is pressed, the READY indicator will
) indicator will go out when copying starts.
) button.
) indicator will start to blink.
) button during warm-up. Copying will start after warm-
)
)