Using The Adf - Sharp SF-1116 Operation Manual

AUTOMATIC DOCUMENT FEEDER (SF-A18)

Using the ADF

Be sure to remove any staples or paper clips from the
originals.
Damaged or crumpled originals may misfeed in the
document feeder. It is recommended that these
originals be copied from the document glass.
For best feeding of originals which have binding
holes punched into them, insert them so that the
holes are positioned to the right or along the side
guides.
A3
A4
A4
R
A5
B4
8 13
1
2
EXTRA
1 2 3
4 5 6
8 9
7
0/ C
50
Special originals such as transparency film and tracing
paper should not be fed through the document feeder
but should be copied from the document glass.
Image loss (max. 4 mm (5/32")) can occur at the
leading and trailing edges of the copies.
Stream feeding mode
If the stream feeding mode has been enabled using user
program No. 5, the original feed indicator will continue to blink
for approximately 5 seconds after feeding of all originals is
completed. While this indicator is blinking, any new originals
placed in the document feeder will be fed and copied
automatically. See page 30, USER PROGRAMS.
1 Set the original guides to the width of the originals, and
set the originals face up in the document feeder tray.
If an original is left on the document glass, the original reminder
indicator will blink. Remove the original from the document
glass in this case.
2 Ensure that the copy paper size in the paper tray is the
same size as the original.
If an optional multi bypass feeder is installed, use the TRAY
SELECT (
paper the same size as the original.
3 Select all other desired copier functions, set the number
A
of copies, and press the print (
To cancel a copy run, press the clear all (
stop. An original will be left on the document glass and the
original reminder will light up.
) key to select the paper feed station containing
) button.
) key. Copying will