Cisco CAtalyst 4500 Series Installation Manual page 94

Rack-Mounting the Switch
Table 3-1
Quantity
2
6
6
Note
Install the L brackets, which connect the chassis to the rack, as follows:
Step 2
a.
b.
Catalyst 4500 Series Switches Installation Guide
3-6
Rack-Mount Kit Checklist
Part Description
L brackets
M4 Phillips pan-head screws
12-24 x 3/4-inch Phillips binder-head screws
Some equipment racks provide a power strip along the length of one of
the rear posts. If your rack has this feature, consider the position of the
strip when planning fastener points. Before installing the L brackets on
the chassis, determine whether to install the chassis from the front or the
rear of the rack.
Remove the screws from the front of the switch side-cover panels.
Attach the left and right L brackets using the six M4 Phillips pan-head screws
(three screws per side) provided in the rack-mount kit.
See Figure 3-1 for the Catalyst 4503 switch,
switch, or Figure 3-3 for the Catalyst 4507R switch, or
Catalyst 4510R switch.
Chapter 3 Installing the Switch in a Rack
Figure 3-2 for the Catalyst 4506
Figure 3-4 for the
78-14409-08