Table of Contents
Advertisement
All access points with WPS function enabled will be displayed here. Please make sure
the access point you wish to connect is displayed. If not, please click Rescan few more
times. You can also click Information button to see the detailed information about
selected access point.
5.
Start PBC pairing procedure at access point side (please refer to the instruction given by
your access point's manufacturer), then click PBC button in wireless configuration
utility to start to establish wireless connection by WPS. Please be patient (This may
require several seconds to one minute to complete). When you see WPS status is
connected successfully message, means the connection between this wireless network
card and access point is successfully established by WPS, and the information about
access point you connected to will be displayed.
6.
You can click Detail button to see detailed information of connected access point. If you
wish to save this connection as a profile, you can click Export Profile button, and this
connection will be saved. You can find this connection in Profile tab in a later time.
7.
Sometime WPS may fail (In the following picture, WPS pairing is failed because no
WPS-enabled access point is found):
You can click PBC button few more times to try again. When an access point is
connected, you can click Disconnect to disconnect your wireless network card from a
connected access point, or select another WPS-enabled wireless access point, then click
Connect to establish connection to selected access point, if there are more than one
WPS-enabled access point found. You can also click Rotate button, and next access
point on the list will be selected to establish connection.
If you want to delete a found access point from the list, select it and click Delete button.
3
.
6
.
2
W
P
S
S
e
3
.
6
.
2
W
P
S
S
e
If the wireless access point you wish to connect supports PIN, please follow the following
instructions to establish connection to it:
1.
Right-click VigorN65 configuration utility icon located at lower-right corner of computer
desktop and then click Launch Config Utility.
VigorN65 User's Guide
t
u
p
-
P
I
N
t
u
p
-
P
I
N
41
Advertisement
Table of Contents
