Powering Off The Cs1000 - RIDGID SeeSnake CS1000 Operator's Manual

Figure 45 – Resuming a Closed Job
If a job has been interrupted by the unit being shut down
unexpectedly, such as by a power outage, a prompt asking
you if you want to resume the job will appear when the unit
is started up again.

Powering OFF the CS1000

Power OFF your CS1000 by pressing the Power Key
either on the Main Keypad or on Mini Keypad. There will
be a 3-second power down countdown after you press
the Power Key . Cancel the power down countdown by
pressing any of the keys on the main keypad.
Abnormal Shutdown
If the CS1000 powers OFF abnormally, the equipment will
perform a systems check to inspect and repair any damage
the next time it powers ON. A systems check can take a
few minutes. The following events may result in a systems
check:
y An unexpected power outage during use.
y Unplugging the CS1000 when it is still ON.
Close or Pause a Job
If you try to power OFF the CS1000 when a job is open you
will be asked if you want to close or pause the job before
powering down.
Figure 46 – Close or Pause a Job
y Choose "Close Job and Power Down" to close the
job and turn OFF the CS1000. To resume the job in
the future select if from your "Resume Job" list.
y Choose "Pause Job and Power Down" to pause
the job and turn OFF the CS1000. The next time you
turn the CS1000 ON you will be asked if you want to
resume your paused job. This is especially convenient
if you want to take a quick break without using your
batteries or if you want to move to a new inspection
entry point at the same job location.
Recycling Jobs
Remove Jobs from the Job Browser by sending them to the
Recycle Bin.
Figure 47 – Select Jobs to Recycle
1. Open the Job Browser using one of the following
methods:
y Press the Menu Key
to navigate to the Job Browser icon
press the Select Key
y Press the Job Manager Key
Arrow Key
Ridge Tool Company
TM
, use the right Arrow Key
to open the Job Browser.
, use the down
to navigate to "Browse Reports,"
English - 25
, and