Connecting The Cs1000; Powering The Cs1000 - RIDGID SeeSnake CS1000 Operator's Manual

Connecting the CS1000

System Connector
2
Figure 10 – Connecting SeeSnake System Cable to CS1000
System Connection
1. Unwrap the SeeSnake System Cable from its holder
and insert the System Cable plug into the SeeSnake
System Connector (Item 1, Figure 10) on the front
edge of the keyboard.
2. To join the connectors, align the guide pin to the guide
socket, push the connector straight in. A guide ridge
(Item 2, Figure 10) molded into the top of the cable
connector will point up when the plug is correctly
aligned.
3. Tighten the outer locking sleeve (Item 3, Figure 10).
NOTICE
When connecting or disconnecting the
System Cable, twist only the locking sleeve! To prevent
damage to pins, never bend or twist the connector or
cable!
Additional CS1000 Ports
There are four ports located behind the red rubber connector
cover on the front edge of the keyboard.
Figure 11 – CS1000 Ports
NOTICE
The areas behind the connector cover,
containing the USB ports, Video Out Port, and Factory
Interface Port are not internally sealed. Keep the connector
cover in place in wet or moist conditions to prevent
damage to the ports.
USB Ports
The two USB ports are suitable for thumb drives or other
storage devices. Use any one USB port at a time.
Video Out Port
1
The Video Out Port enables you to connect the CS1000
to an external monitor for video display. The Video Out
Port only outputs audio on video playback and not during
3
recording.
Factory Interface Port
To perform diagnostics the manufacturer will use the Factory
Interface Port. Do not use the Factory Interface Port for
other devices.
Connection Icons

Powering the CS1000

The CS1000 can be powered with one or two RIDGID Li-
Ion rechargeable battery or plugged into an outlet using
a AC/DC power converter. Battery power is the preferred
powering method to reduce the risk of electrical shock. The
power converter is not rated for outdoor use. Only use the
CS1000 indoors when powered with the AC/DC converter.
Battery Power
1. With dry hands, insert one or two 18 V Li-Ion batteries
into the battery docks in the back of the unit. The unit
can be tilted forward and rested on the closed face for
convenience.
2. The batteries are rated for 2.2 amp-hours each. Actual
operation time on batteries will vary depending on use.
The CS1000 will run for approximately 1.75 hours with
a single, fully charged battery, and approximately 4.5
hours with two fully charged batteries.
3. Only recharge the batteries with the approved charger.
Attempting to charge batteries with the wrong charger
can damage the batteries.
Ridge Tool Company
TM
Table 3
Connection Icons
Video Out
Transmitter Clip-on Terminal
English - 11