Table of Contents
Advertisement
Inspection Overview
WARNING
Wear appropriate protective equipment
such as latex or rubber gloves, goggles,
face shields, and respirators when in
specting drains that might contain haz
ardous chemicals or bacteria. Always
wear eye protection against dirt and
other foreign objects.
The following is an overview of how to per-
form a pipe inspection with your SeeSnake
system:
1. Connect the monitor to a camera reel
with the system cable.
2. Press the Power key
3. Carefully put the camera into the pipe.
Protect the push cable from sharp
edges at the pipe entrance.
4. Push the camera through the pipe and
observe the display.
5. Depending on the requirements for the
job, you may want to include one or
more of the following:
• Capture media.
• Stream live video to your mobile
device and share media with cus-
tomers.
• Take a temporary segment dis-
tance measurement.
• Add custom overlay.
• Review the job, captured media,
and preview the report.
• Deliver a report to your customer
on a USB drive.
Connecting to a Camera Reel
The CS12
camera reel with the See Snake system
cable.
1. Pull back the outer locking sleeve on
2. Align the connector ridge and plastic
3. Tighten the outer locking sleeve.
NOTICE
.
Outer Locking Sleeve
Powering the System
NOTICE
The system is powered by a compatible 18
V Li-Ion rechargeable battery or AC adapt-
er. Battery run time will vary according to
battery capacity and use. When copying
lengthy jobs or large batches of jobs use an
AC adapter.
Note: The AC adapter does not recharge
the 18 V battery.
can connect to any See Snake
x
the system cable connector.
guide pin with the socket and push the
connector straight in.
Only twist the outer lock
ing sleeve. To prevent
damage to the pins, never
bend or twist the connec
tor.
Socket
Guide Pin
Unexpected power loss
may result in data loss
and corruption.
CS12
x
Connector Ridge
– English – 11
Advertisement
Table of Contents
