RIDGID SeeSnake CS1000 Operator's Manual page 14

Checking Battery Status: Icons
You can monitor your battery levels using the two battery
icons in the bottom left corner of the screen. Table 4 shows
the on-screen battery indicator icons.
Figure 12 – On-Screen Battery Icons
Table 4
On-Screen Battery Icons
Checking Battery Status: LEDs
The CS1000 has four battery indicator LEDs, two for each
battery, located just below the screen.
Figure 13 – Battery Indicator LEDs
When the unit is turned ON and there are batteries in the
battery docks, the LEDs on the CS1000 will reflect the state
of each battery as shown in Table 5.
12 - English
TM
Full charge
Partial charge
Battery low
No charge
AC power
Ridge Tool Company
Table 5
Battery Status LED Indicators
LED Behavior
Left LED is Green
Right LED is OFF
Left LED is Green
Right LED is Red
Left LED is OFF
Right LED is Red
Blinking red and
beeps
Solid red and
continuous tone
Slow blink
Outlet Power
NOTICE
The provided external power supply is
intended for indoor use only.
For plug-in operation, a double insulated AC/DC power
cord is supplied to reduce wall outlet voltage to the correct
voltage for the CS1000.
1. To power the system using AC power with the power
cord, locate the power cord on the back of the unit.
Unhook the Velcro® strap and remove the plug from
its holder.
2. With dry hands, plug the power cord into an approved
outlet. If using an extension cord ensure the use of
adequate wire gauge. For cords no greater than 25 ft
[7.6 m] long, use a wire gage of at least 18 AWG is
required. For cords longer than 25 ft [7.6 m], use a wire
gauge of at least 16 AWG.
3. Never power the unit from AC using the power cord in
a wet environment.
Sometimes you may need to move locations during a job. If
you are running your CS1000 using AC power and have at
least one battery in the rear battery docks, you can unplug
the CS1000 to move it without powering it OFF.
Meaning
Battery full charge
Battery partial charge
Battery low
Replace batteries immediately.
Shutdown in 1 min
Dead batteries.
Shutdown in 5 sec
External power in use.
Beeps when disconnected