Table of Contents
Advertisement
Inspection Overview
WARNING
Wear appropriate protective equipment such as latex
or rubber gloves, goggles, face shields, and respira-
tors when inspecting drains that might contain hazard-
ous chemicals or bacteria. Always wear eye protection
against dirt and other foreign objects.
The following is an overview of how to perform a pipe in-
spection with your SeeSnake system:
1. Connect the monitor to a camera reel with the system
cable.
2. Press the Power key
3. Carefully put the camera into the pipe. Protect the push
cable from sharp edges at the pipe entrance.
4. Push the camera through the pipe and observe the dis-
play.
5. Depending on the requirements for the job, you may
want to include one or more of the following:
• Capture media.
• Stream live video to your mobile device and share
media with customers.
• Locate an inspection point or path.
• Take a temporary segment distance measurement.
• Add custom overlay.
• Review the job, captured media, and preview the
report.
• Deliver a report to your customer on a USB drive.
.
Connecting to a Camera Reel
The CS6xPak can connect to any SeeSnake camera reel
with the SeeSnake system cable.
1. Pull back the outer locking sleeve on the system cable
connector.
2. Align the connector ridge and plastic guide pin with the
socket and push the connector straight in.
3. Tighten the outer locking sleeve.
NOTICE
Only twist the outer locking sleeve. To pre-
vent damage to the pins, never bend or
twist the connector.
Connector Ridge
Outer Locking Sleeve
Powering the System
NOTICE
Unexpected power loss may result in data
loss and corruption.
The system is powered by a compatible 18 V Li-Ion re-
chargeable battery or AC adapter. Battery run time will vary
according to battery capacity and use.
Note: The AC adapter does not recharge the 18 V battery.
Guide Pin
Socket
CS6xPak – English – 11
Advertisement
Table of Contents
