Sony Handycam Vision DCR-TRV9 Operating Instructions Manual page 7

Before using your camcorder, you first need to charge and install the batte_ T pack. To
charge the batte_31 pack, use tile supplied AC power adaptor.
Cbarge tile battery pack oil a flat surface without vii)ration. _
(1) Connect tile power cord to a wall ontlet.
(2) Align the surface of the battery pack indicated by tile I_ mark with the edge of tbe =
terminal shutter of the AC power adaptor. Then fit and slide the hattery pack in the
dilection of tbe arrow. The CHARGE lamp (orange) lights up. Charging begins.
When the CHARGE lamp goes out, normal charge is completed. For full charge, which
allows you to use the battery longer than usual, leave the battel T pack in place for
approximately one hour. Uni)lug the trait flora the wall outlet, then remove the battery
pack and install it into the camcorder. You can also use tbe battery pack before it is
completely charged.
Charging time
Battery pack Charging time *
NP F330 (supplied) 130 (70)
NP F530 170 (110)
NP F550 180 (120)
NP F730 250 (190)
NP F750/NP F730H** 270 (210)
NP F930 330 (270)
NP F950 360 (300)
The time required for a normal charge is indicated in parentheses.
Approximate minutes to charge an empty battery pack
t/siI'lg
the supplied AC power
adaptor. (Lower temperatures require a longer charging time.)
** NP F730H is soM only in the U.S.A.