Playback Pause - Sony Handycam Vision DCR-TRV9 Operating Instructions Manual

You can insert a new scene from a VCR onto your originally recorded tape by specifying
starting and ending points. After inserting editing, the previous picture and sound will be
erased.
Connection is tile same as on page 61 or 63. In recording and recording pause mode, DV
IN/OUT jack automatically works as input jack.
(1) While pressing the small green button on the POWER switch, set it to VTR.
(2) On the VCR, locate the start point to be inserted and set it to playback pause mode.
(3) On the camcorder, press C:> to set it to playback mode, and then locate the point
where the insert should end by pressing _ or It,_. Then press || to set it to
playback pause mode.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY
indicator flashes and the end point of the insert is stored in inemory.
(5) On the camcorder, locate the point where the insert should begin by pressing 41_1.
then press • REC to set it to recording pause mode.
(6) Press | | on the camcorder and the VCR simultaneously to start insert editing.
The insert editing stops automatically near the counter's zero point. Press [] to set the
camcorder to stop mode.
To change the end point
Press ZERO SET MEMORY on the Remote Commander so that the ZERO SET MEMORY
indicator disappears and begin Dora step 3.
Note on the inserted picture
The picture may be distorted at the end of the inserted portion when it is played back.
64