Table of Contents
Advertisement
ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
Under the Monitoring tab, select System on the main menu to view the System screen, shown in
Figure 3-11
below. This screen shows the parameters listed in
Table 3-1. System Information Fields
Field
Access Point Information
Access Point Name
MAC Address
Country/Region
Firmware Version
Access Point Mode
Current IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current Wireless Settings for 802.11n/g
Operating Mode
Channel/Frequency
Rogue AP Detection
3-14
Description
Indicates the NetBIOS name. The default name may be changed, if desired.
Displays the Media Access Control address (MAC address) of the wireless
access point's Ethernet port.
Displays the domain or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access point in
a region other than one of those identified in this field.
The version of the firmware currently installed.
Identifies the operating mode of the WNDAP330: Access Point, Point-to-
point bridge, Point-to-point bridge with Access Point, Multi-point bridge or
Repeater.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
Enabled indicates that the current IP address was obtained from a DHCP
server on your network. Disabled indicated a static IP configuration.
Identifies the 802.11 operating mode of the WNDAP330.
Identifies the channel the wireless port is using. 11 is the default channel
setting. (Channel frequencies used on each channel can be found in "Wire-
less Communications"; a link to this article is in
).
Documents".
Identifies whether the Rogue AP detection feature is enabled or disabled.
v1.0, May 2008
Table
3-1:
Appendix B, "Related
Management
Advertisement
Table of Contents
