ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
•
Baud rate: 9600 bps
•
Data bits: 8
•
Parity: none
•
Stop bit: 1
•
Flow control: none
These settings appear below the connector on the back panel.
3. Press Enter. The screen shown below in
Figure 3-3
4. Enter the login name and password (admin and password are the defaults).
After successful login, the <Access Point Name> prompt should appear. In this example, the
prompt is netgear74F35E.
5. Enter
to display the CLI command help.
help
CLI Commands
The CLI commands are listed in
3-4
Figure 3-3
Appendix C, "Command Line
v1.0, May 2008
should appear.
Reference."
Management