Table of Contents
Advertisement
•
Aggregation Support
•
Reduced InterFrame Spacing support
•
Multiple Input, Multiple Output (MIMO) support
•
Distributed coordinated function (CSMA/CA, Back off procedure, ACK procedure,
retransmission of unacknowledged frames)
•
RTS/CTS handshake
•
Beacon generation
•
Packet fragmentation and reassembly
•
Auto or long preamble
•
Roaming among access points on the same subnet
Autosensing Ethernet Connections with Auto Uplink
The WNDAP330 can connect to a standard Ethernet network. The LAN interface is autosensing
and capable of full-duplex or half-duplex operation.
The wireless access point incorporates Auto Uplink
automatically sense whether the Ethernet cable plugged into the port should have a "normal"
connection such as to a computer or an "uplink" connection such as to a switch or hub. That port
will then configure itself to the correct configuration. This feature also eliminates any concerns
about crossover cables, as Auto Uplink will accommodate either type of cable to make the right
connection.
Compatible and Related NETGEAR Products
For a list of compatible products from other manufacturers, see the Wireless Ethernet
Compatibility Alliance Web site (WECA, see http://www.wi-fi.net).
The following NETGEAR products work with the WNDAP330 Wireless Access Point:
•
FS108P - ProSafe 8 Port 10/100 Switch with 4 Port PoE
•
FS116P ProSafe 16 Port 10/100 Desktop Switch with 8 Port PoE
•
FS726TP - ProSafe 24 Port 10/100 Smart Switch with 2 Gigabit Ports and 12 Port PoE
•
FS728TP - ProSafe 24+4 10/100 Smart Switch with full PoE
•
FS752TPS - ProSafe 48 Port 10/100 Stackable Smart Switch with 4 Gigabit Ports and 24 Port
PoE
•
FSM7328PS - ProSafe 24-port 10/100 L3 Managed Stackable Switch with 24 PoE Ports
Introduction
ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
v1.0, May 2008
technology. The Ethernet port will
TM
1-5
Advertisement
Table of Contents
